Vaughan Doors Installation

Vaughan Doors Installation

Vaughan Door Installation 647-951-3510

Vaughan Doors Installation

Vaughan Doors Installation

While installing a door, the first thing you need to do is measure the height and width of the opening. Though the height is not an important factor in case of an interior door, you must be very careful while measuring it for your entrance. For the width, you need to keep in mind that it will differ at the middle, bottom, and top. Once the measurement is done you will need to the remove the hinges of the old one, in case of reinstallation. Now install the leaf of the new hinge in your jamb. You can use a circular saw to cut this fixture according to the required width. It is better to use a saw guide in order to get a precise cut.

 

When installing the door, also remember to place some shims on your floor underneath the fixture.

In the opening only one leaf of the new hinge will be attached to the jamb. Make sure that the barrel of these hinges faces you. Slide the shims in that are placed on the floor with your foot. This is to be done while lifting up the fixture so as to get your required gap at the top. You will also have to place another shim at the top in order to hold that gap in place. It is advisable to push these shims sideways rather than pushing them straight in as the distance is small. You will need to repeat the same process on the latch side of your entrance. Once you have placed your fixture in its exact location, mark the bottom and top of the hinge with a pencil.

 

You will require a butt gauge to outline the location of the hinge.

Now place your fixture in the opening and join the leaves of the hinges. Finally, compress the pin into the barrel. In case, it is not properly placed, loosen the screws and move the leaves of your hinges a little until they meet. And re-tighten the screws of the hinge. Next comes drilling for the lock and installing it. Finally open and close the gate and check for proper gaping. Make sure there is no binding.

 

Another factor that you need to consider is whether you need a solid or hollow core.

Both of them have certain advantages and disadvantages. Those with solid core are stronger. However, they are very heavy and are hard to handle. On the other hand, such fixtures with hollow cores are much lighter and are also cost effective.

It is also advisable to get such services from professionals. There are many companies that provide such services. To find them online you can simply type phrases like ” Door installation Austin ” or with the name of your local area. Go for the one that has experience and offers the best deal available.

 

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *