High-speed door stuck, crashing, torn, or dropping out of its guides? Ontario Door Repair services and repairs rapid-roll and high-speed doors for warehouses, food plants, cold storage and parking across Toronto and the GTA - same day, 24/7.
A high-speed door earns its keep by cycling hundreds of times a day - separating temperature zones, speeding up traffic and keeping dust, pests and cold out. When it faults, everything backs up: forklifts wait, cold rooms warm up, and an open dry-food or clean area is suddenly exposed.
We repair rapid-roll fabric doors and high-speed rigid doors: torn or worn curtains, drive and VFD faults, encoders, photocells and safety loops, brakes and springs, and breakaway sections that won't reset after an impact. We get the door cycling safely again and, where it makes sense, upgrade weak points so it stops failing. For the overhead and dock openings beside them we also handle loading dock door repair.
Not sure of your door brand? Send a photo of the control panel and header - we work on virtually every make of high-speed and rapid-roll door and can source parts for older units.
These are the faults we get called for most - all repairable, and we carry common parts for same-day fixes.
A failed drive, VFD, encoder or control board stops the door mid-cycle. We diagnose the electronics and get it cycling again.
Impacts and daily wear tear the fabric curtain. We repair or replace the curtain and wind bars so the door seals and runs true.
After a hit, the curtain can jump the side guides. We re-seat the curtain, straighten or replace guides, and check the wind-lock.
Blocked or misaligned photocells and floor loops stop the door or fault it out. We realign and repair the safety devices to spec.
Breakaway bottom bars are designed to release on impact and re-set - when they don't, we repair the mechanism and re-tension the door.
Worn brakes, springs, bearings or drive belts rob speed and cause noise. We service the mechanism and restore full cycle speed.
We also service seals and bottom edges for cold-storage and clean-area doors, and can advise on impactable, self-repairing curtains where forklifts keep causing damage.
We test the drive, controls, sensors and curtain on site to pinpoint the true fault - fast.
A clear, firm price before we start. No surprise charges.
We stock common curtains, photocells, brakes and drive parts for first-visit repairs.
We reset breakaway, recalibrate speed and test all safety devices before we leave.
Same-day service for the operations where an open or dead high-speed door means spoilage, contamination or a traffic jam.




Same-day & 24/7 rapid-roll door repair across Toronto & the GTA - we get your line moving again.
Every job is quoted after diagnosis. These are typical GTA ranges - you always get a firm price first.
Ranges are estimates for typical repairs and vary by brand, parts and site conditions. Call (647) 951-3510 for an exact quote.
20+ years on commercial and industrial doors across the GTA - warehouses to food plants.
Downtime is expensive and risky. We respond fast and stock the parts to finish.
Fully licensed, insured technicians and a warranty on every repair.
Rytec, Hormann, Albany, Dynaco, Nergeco and more - one call covers it.
We reset breakaway and verify photocells and loops so the door is safe to run.
Repair and reinforce weak points; replace only when it truly makes sense.
Same-day service throughout Toronto and the Greater Toronto Area, including:
Often we can repair minor tears and re-seat a curtain that has jumped its guides. Larger tears or worn-out fabric are more cost-effective to replace, and we can supply an impactable, self-repairing curtain if forklifts keep causing damage. We will tell you honestly which makes sense.
Yes. Most high-speed doors have a breakaway bottom section designed to release on impact and re-set. When it won't reset, the mechanism, wind bars or curtain usually need service. We repair the breakaway, re-seat the curtain and re-tension the door.
Yes. We service rapid-roll and high-speed doors on coolers, freezers and controlled environments, including seals and bottom edges that keep temperature and humidity where they belong.
Usually same day. A dead high-speed door backs up forklifts and exposes temperature or clean zones, so we prioritize it and carry common photocells, brakes, guides and drive parts for first-visit repairs.
Rytec, Hormann, ASSA ABLOY/Albany, Dynaco, Nergeco, Chase, TNR and more, including older units. Send a photo of the control panel and we will identify the make and source parts.
Yes. We offer round-the-clock emergency service across the GTA so a failed high-speed door does not shut down your operation overnight.
Dock doors, levelers, seals and bumpers for warehouses and DCs.
Roll-up and coiling steel door repair for commercial and industrial sites.
Full commercial door service across the GTA.
Sectional and overhead garage door repair and service.
Automatic swing, sliding and ADA operators repaired same-day.
Round-the-clock emergency door service across the GTA.
Talk to a real technician now - same-day & 24/7 high-speed and rapid-roll door repair across Toronto & the GTA.
