Automatic Door Operator Repair in Toronto & the GTA
Automatic door won’t open, sticking half-way, staying open, or reversing on you? Ontario Door Repair services and repairs commercial swing, sliding and low-energy ADA door operators across Toronto and the GTA — same day, 24/7.
- All major operator brands
- Swing, sliding & ADA push-button
- AODA / accessibility compliant
- Licensed & insured technicians
Get a Fast Free Quote
Fast, code-compliant automatic door operator repair
An automatic door operator is the motorized system that opens your door for you — the header-mounted unit, the control board, the activation switches and the safety sensors that work together every time someone approaches. When any one part fails, the whole entrance stops working, and for a busy storefront, clinic, office lobby or retail plaza that means blocked accessibility, security gaps and lost foot traffic.
Our technicians repair the operators most Toronto and GTA buildings actually run: low-energy ADA push-button operators (the blue-button accessibility doors), full-power automatic swing operators, and automatic sliding door operators on storefronts and entrances. We diagnose the real cause, carry common parts on the truck for same-day fixes, and test every repair back to the safety standards these doors are required to meet — so you pass an accessibility inspection and nobody gets caught in a closing door.
If your operator brand isn’t listed, call us anyway — we work on virtually every make of commercial operator and can source parts for older or discontinued units.
Automatic door problems we fix
Most calls we get fall into one of these faults. All of them are repairable — usually the same day.
Door won’t open
Dead operator, tripped breaker, blown fuse, failed motor or gearbox, or a control board that lost its program. We test power, board and motor to find the true fault.
Opens slowly or half-way
Worn drive belt, failing motor, low battery backup, or speed/force settings drifting out of spec. We restore correct opening speed and hold-open time.
Won’t close / stays open
Stuck sensor, misaligned safety beam, seized arm linkage or a hold-open switch left engaged. We clear the fault so the door cycles properly again.
Reverses or slams
Faulty presence sensor, header photo-eye, or force settings that fail the safety test. We recalibrate to ANSI A156.10 / A156.19 so the door is safe to walk through.
Push plate / actuator dead
Wall push plates, wireless actuators and receivers wear out or lose signal. We repair or replace hardwired and wireless activation and release hardware.
Noise, grinding, dragging
Worn spindle, bearings, rollers or a binding arm. We service the mechanism and the closer / operator linkage before it fails completely.
We also handle battery backups, breakout (swing-out) doors, obstruction faults, integration with maglocks and access control, and full operator replacement when a unit is beyond economical repair.
How our automatic door repair works
Diagnose
A licensed technician tests the operator, board, sensors and hardware on site to pinpoint the exact fault — not guesswork.
Upfront quote
You get a clear price before we start. No surprise charges, no pressure.
Repair same-day
We carry common operator parts, sensors and boards, so most repairs are completed on the first visit.
Safety test
We recalibrate speed, force and hold-open, then test to accessibility safety standards before we leave.
Accessibility & commercial doors we service
In Ontario, accessible automatic entrances aren’t optional — they’re how customers, patients and tenants get through your door. A broken operator can put you offside on accessibility requirements and turn people away.
- Retail storefronts & shopping plazas
- Medical clinics, dental & pharmacies
- Office towers & lobby entrances
- Condo & apartment building entries
- Restaurants, grocery & convenience
- Schools, community & government buildings
Automatic door stuck open or won’t open?
Same-day & 24/7 emergency operator repair across Toronto & the GTA — we secure your entrance fast.
Automatic door operator repair cost in Toronto (2026)
Every job is quoted after diagnosis, but these are the typical GTA ranges customers ask about. You always get a firm price before any work starts.
Ranges are estimates for typical repairs and vary by brand, parts and site conditions. Call (647) 951-3510 for an exact quote.
Why Toronto businesses call Ontario Door Repair
20+ years on the tools
Two decades repairing commercial and automatic doors across the GTA — we’ve seen your fault before.
Same-day & 24/7
An open or dead entrance is a security and access emergency. We come fast and stock the parts to finish.
Licensed & insured
Fully licensed, insured technicians and a warranty on every repair we complete.
All major brands
BEA, Nabco, Horton, Stanley, Record, dormakaba, Ditec, Tormax and more — one call covers it.
Safety-tested repairs
Every operator is recalibrated and tested to accessibility safety standards before we leave.
Honest, upfront pricing
A clear quote before we start. Repair when it makes sense, replace only when it doesn’t.
Automatic door operator repair across the GTA
Same-day service throughout Toronto and the Greater Toronto Area, including:
Automatic door operator repair FAQ
My automatic door won’t open at all — what’s wrong?
Start with power: a tripped breaker, blown fuse or a switch left in the “off/manual” position stops most operators cold. If power is fine, the usual culprits are a failed control board, a dead motor/gearbox, or a safety sensor that has faulted the door into lock-out. Our technician tests each in sequence and, in most cases, has the door cycling again the same day.
Can you fix the door the same day?
Usually, yes. We carry common operator parts — sensors, boards, belts, actuators and switches — on the truck, so most Toronto and GTA repairs are completed on the first visit. If a specialty part has to be ordered, we’ll secure the entrance and get you running as fast as the part allows.
Do you repair the blue “accessibility” push-button doors?
Yes. Those are low-energy ADA operators, and they’re one of the most common units we service. We repair the operator, the wall push plates and wireless actuators, the receiver, and recalibrate the open speed and hold-open time so the door meets accessibility safety requirements.
Is it cheaper to repair or replace an automatic operator?
Most operator faults — sensors, boards, belts, worn arms — are far cheaper to repair than to replace the whole unit. We only recommend replacement when the operator is obsolete, unsafe, or the repair cost approaches a new unit. You’ll get an honest recommendation and a firm quote either way.
What brands of automatic door operators do you work on?
Virtually all of them: BEA, Nabco/GYRO TECH, Horton Automatics, Stanley/Dura-Glide, Record, dormakaba/Besam, Ditec, Tormax, Camden and Detex, plus older and discontinued units. If you’re not sure of your brand, send us a photo of the header unit and we’ll identify it.
Do you offer emergency service if the door is stuck open overnight?
Yes — we offer 24/7 emergency service across the GTA. A door stuck open is a security and heating/cooling problem, so we prioritize it, secure the opening, and repair the operator so your building is safe again. See our 24/7 door repair service.
Related door services
Commercial Door Repair
Full commercial door service for storefronts, offices and industrial sites across the GTA.
Door Closer Repair
Hydraulic and surface closer repair, adjustment and replacement for busy commercial doors.
Electric Strike Repair
Electric strikes and release hardware that tie into buzzer entry and access control.
Magnetic Lock Repair
Maglocks and access-controlled entrances repaired and integrated with your operator.
Panic Bar & Exit Devices
Exit hardware repair and installation to keep egress doors code-compliant.
Storefront Entry Doors
Aluminum and glass storefront entrance repair, pivots, closers and hardware.
Get your automatic door working today
Talk to a real technician now — same-day & 24/7 automatic door operator repair across Toronto & the GTA.