Buzzer won't release the door, maglock won't let go, or the fob reader is dead? Ontario Door Repair repairs access-controlled and buzzer-entry doors for condos, apartments and offices across Toronto and the GTA - same day, 24/7.
When an access-controlled door fails, it fails in one of two bad ways: it won't let residents and staff in, or it won't lock and anyone can walk in. For a condo lobby, apartment entrance or office suite, either one is urgent - it's a security and access problem at your most-used door.
We repair the hardware that controls the door: electric strikes, magnetic locks, keypads, fob and card readers, buzzer and intercom release, request-to-exit sensors, door position switches and power supplies. We get the door releasing on command and re-locking securely, and we tie the release back to your buzzer or intercom. We work on the door hardware and wiring at the opening - complementing your alarm or access-system provider. Related: electric strike repair and magnetic lock repair.
We repair the door hardware and its wiring at the opening. If your system needs programming from your access-control provider we'll tell you exactly what's the door and what's the software.
Most access-door calls come down to one of these - all repairable, and we prioritize anything that leaves a door unsecured.
A failed electric strike, power supply or wiring fault means the buzzer clicks but the door won't open. We trace the release circuit and repair the strike or supply.
Magnetic locks fail to hold (door not secure) or fail to release (people trapped). We repair or replace the maglock, armature and controls, and verify safe egress.
Worn or failed keypads and fob/card readers stop valid users getting in. We repair or replace the reader and its wiring at the door.
A strike that buzzes but won't let the door open is usually binding, misaligned or under-powered. We re-align the strike and correct the power.
A door that won't re-lock or throws a held-open alarm is a security risk. We repair the closer, strike, sensor or maglock so it secures every time.
Request-to-exit sensors and exit buttons must release the door to let people out. We repair REX devices and exit hardware so egress is safe and code-compliant.
We also repair the closer, hinges and alignment that access hardware depends on, and coordinate with your access-control or alarm provider when programming is involved.
We test the strike, maglock, reader, power and wiring at the door to find the real fault.
A clear, firm price before any work begins.
We carry common strikes, maglocks, power supplies and hardware for first-visit fixes.
We verify the door releases on command, re-locks securely and lets people exit safely.
Same-day service for the entrances where a failed access door locks people out - or leaves the building open.




Same-day & 24/7 access control & buzzer entry repair across Toronto & the GTA - we secure your entrance fast.
Every job is quoted after diagnosis. These are typical GTA ranges - you always get a firm price first.
Ranges are estimates for typical repairs and vary by brand, parts and site conditions. Call (647) 951-3510 for an exact quote.
20+ years on electric strikes, maglocks and access hardware across the GTA.
A failed access door is a security emergency - we come fast and secure you.
Fully licensed, insured technicians and a warranty on every repair.
We make sure people can always get out safely, to code, on every release.
We handle the door and wiring and work with your access or alarm provider on programming.
A clear quote before we start - repair or replace, your call.
Same-day service throughout Toronto and the Greater Toronto Area, including:
Yes. That is usually a failed electric strike, a power-supply problem or a wiring fault in the release circuit. We trace the circuit at the door, repair or replace the strike or supply, and confirm the door releases reliably when buzzed.
It can be, because people must be able to exit. We treat maglock release faults as urgent: we repair or replace the maglock and its controls, verify the request-to-exit and fire release, and make sure egress is safe and code-compliant.
Yes - we repair and replace the reader hardware and wiring at the door (keypads, fob and card readers). If the problem is in the access-control software or a user database, we will identify that so your system provider can program it.
Yes. A door that won't re-lock or throws a held-open alarm is a security risk. We repair the strike, maglock, closer or sensor so the door secures every time it closes.
Yes. We repair the physical door hardware and wiring at the opening and coordinate with your access-control or alarm company where programming is required, so nothing falls between the two of us.
Yes, across the GTA. If an entrance won't secure or won't let residents and staff in, we respond fast, make it safe, and complete the repair.
Electric strikes and release hardware for buzzer and access entry.
Maglocks, armatures and controls repaired and verified for safe egress.
Automatic operators that tie into access and accessibility.
Exit hardware and request-to-exit for code-compliant egress.
Full commercial door service across the GTA.
Round-the-clock emergency door and access repair.
Talk to a real technician now - same-day & 24/7 access control and buzzer entry repair across Toronto & the GTA.
