these locks are gravity-based, so you can open the drawer by turning the cabinet upside down. If it does not work, you can drive a regular drill bit straight through the cylinder of the lock. It should be done carefully in order to avoid damage to your cabinet itself. Once you have drilled the lock, the drawer should pull open easily.
Step 2
Then you have to grasp the C-shaped clip at the back of the lock with the pliers. One if you have removed the clip, you have to be able to slide the lock out of the opening.
Step 3
Then you need to install your lock. The specific instruction may vary, but the common procedures are as follows. Place your key in the lock and unsure that it is in the unlocked position. Insert a new lock into the opening and be sure that the key way is upright and the cam is pointing down.
Step 4
After that you have to hold the C-clip flush against the inside wall of your cabinet. Insert the two prongs on the clip into the pre-drilled holes on the lock body in order to secure it in the place.
Step 5
And the last thing that should be done is that you have to make sure the lock bolt on the back of the lock aligns properly with the locking mechanism in your cabinet. You can use your key in order to test the lock before closing the drawer.
Same-day and 24/7 emergency door repair across Toronto and the GTA — on-time appointments, free estimates and a warranty on every job.
Toronto · North York · Scarborough · Etobicoke · Mississauga · Vaughan · Woodbridge · Markham · Richmond Hill · Oakville · Hamilton — and the wider GTA.
